Alarm Port; Cables And Adapters; Sfp Module Cables - Cisco IE 4000 Hardware Installation Manual

Cable and Connectors

Cables and Adapters

Figure 28 USB Type A-to-USB 5-Pin Mini-Type B Cable
The RJ-45 console port uses an 8-pin RJ-45 connector The supplied RJ-45-to-DB-9 adapter cable is used to connect
the console port of the switch to a console PC. You need to provide a RJ-45-to-DB-25 female DTE adapter if you want
to connect the switch console port to a terminal. You can order a kit (part number ACS-DSBUASYN=) containing that
adapter.

Alarm Port

The labels for the alarm connector pin-outs are on the switch panel and are displayed below.
Label
NO
COM
NC
IN2
REF
IN1
Cables and Adapters

SFP Module Cables, page 65

Cable Pinouts, page 68

Console Port Adapter Pinouts, page 70

SFP Module Cables

Each port must match the wave-length specifications on each end of the cable, and for reliable communications, the
cable must not exceed the allowable length.
Notes

The maximum operating temperature of the switch varies depending on the type of SFP module that you use.

Modal bandwidth applies only to multimode fiber.
Connection
Alarm Output Normally Open (NO) connection
Alarm Output Common connection
Alarm Output Normally Closed (NC) connection
Alarm Input 2
Alarm Input Reference Ground connection
Alarm Input 1
65