Cisco IE 4000 Hardware Installation Manual page 55

Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
9. Enter Y to configure the switch as the cluster command switch. Enter N to configure it as a member switch or
as a standalone switch.
If you enter N, the switch appears as a candidate switch in the Cisco Network Assistant GUI. You can configure the switch
as a command switch later through the CLI, Device Manager, or the Cisco Network Assistant application. To configure it
later, enter no.
Would you like to enable as a cluster command switch? [yes/no]: no
You have now completed the initial configuration of the switch, and the switch displays its initial configuration script:
The following configuration command script was created:
hostname Switch
enable secret 5 $1$ZQRe$DPulYXyQLm77v/a4Bmu6Y.
enable password cisco
line vty 0 15
password cisco
no snmp-server
!
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet1/1
!
interface FastEthernet1/2
!
interface FastEthernet1/3
!
...(output abbreviated)
!
interface GigabitEthernet1/1
!
interface GigabitEthernet1/2
!
end
10. These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it in NVRAM by
selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the default configuration that you created. If you want to
change this configuration or want to perform other management tasks, use one of these tools:

Command-line interface (CLI)

Cisco Network Assistant (for one or more switches)
51