Honeywell Satellite XT Manual To Operations page 44

C O N F I G U R A T I O N
N EW S E N S OR T Y P E
s e l e c t : 8
N E W S E N S O R T Y P E
R EMO V E S E N S OR
< s e t > w h e n
N E W S E N S O R T Y P E
N EW S E N S OR
p l e a s e i n s e r t
N E W S E N S O R T Y P E
L O A D N EW D A T A ?
< s e t > t o c o n f i r m
N E W S E N S O R T Y P E
L O A D I NG D A T A !
p l e a s e w a i t
C O N F I G U R A T I O N
G A S N AME
s e l e c t : 9
G A S N A M E
A s H 3
p l e a s e e n t e r
Satellite XT R Version
Allows the user to configure the instrument for a new
sensor type with a part number, which is different from
the one presently used. See Section 8 for Sensor
o f 1 0
Information.
Press the <set> key to enter and follow the dialogue
displayed.
Remove the sensor presently installed and press the
<set> key to proceed.
r e a d y
If you want the data of the new sensor to be loaded,
confirm this by pressing the <set> key.
!
The instrument is now loading the new data from the
sensor into the unit's internal memory.
!
Allows the user to enter a different gas name than the
one stored in the sensor's data memory.
Up to 7 alpha-numeric characters can be entered.
o f 1 0
Use the <set> key to enter. The instrument will display
the actual gas name.
Use the cursor keys <left> or <right> to reach
the desired position. Use the cursor keys <up>
and <down> to select the characters you wish to
!
enter. When the new gas name has been entered
completely, press the <set> key to confirm or
<esc> to exit.
Configuration - Section 6
New Sensor Type
Remove Sensor
Load New Data ?
Loading Data !
Gas Name
<Actual Gas Name>
6-11