Honeywell Satellite XT Manual To Operations page 26

continued
Continued
A L A R M / W A R N T E S T
S E T WA R N I NG ?
s e l e c t :
S E T W A R N I N G ?
Wa r n i n g s e t !
< e s c > t o e x i t
M A I N T E N A N C E
D E V I C E I N F O S
s e l e c t : 4
D E V I C E I N F O S
SW : S X T
_
s h o w i n g :
D E V I C E I N F O S
I D : 0 0 0 1 2 3 4 5 6 7 8 9
s h o w i n g :
Satellite XT R Version
3 o f 3
!
o f 7
X x . x x
1 o f 2
2 o f 2
Maintenance - Section 4
Allows the user to simulate a warning condition.
Actuate the <set> key to enter.
The Fault Relay is activated, depending on the
configuration. Use the <esc> key to exit.
Used to obtain instrument specific information, i.e.
software version and ID number. In general these
informations are required for service purposes.
Actuate the <set> key to select and move with the
cursor keys <up> and <down>. Actuate the <esc>
key to exit.
The version of the software presently installed is
shown.
<Specific Identification Number>
The instrument's specific ID identification number is
shown.
! Note:
Whenever a new sensor is installed, the K-factor
will automatically revert to the default value 1.00.
Any individual settings must be entered again;
refer to section 5, Calibration.
Alarm/Warn Test
Set Warning ?
Warning set !
Device Infos
<Actual Software Version>
4-5