Dell X1000 Series User Manual page 81

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
To add an IPv6 neighbor:
1 Click Switch Management > IPv6 Addressing > IPv6 Neighbors.
The following fields are displayed for previously-defined neighbors:
– Interface—Interface connected to the neighbor.
IPv6 Address—IPv6 address of the neighbor.
–
– MAC Address—MAC address of the neighbor.
– Type—Neighbor discovery cache information entry type (Static or
Dynamic).
– State — The possible states are:
• Incomplete — An address resolution is in progress, and the link-
layer address of the neighbor has not yet been determined.
Reachable — The neighbor is known to have been reachable
•
recently (within tens of seconds).
• Stale — The neighbor is no longer known to be reachable, but
until traffic is sent to the neighbor, no attempt is made to verify
its reachability.
• Delay — The neighbor is no longer known to be reachable, and
traffic has recently been sent to the neighbor. Rather than probe
the neighbor immediately, however, there is a delay sending
probes for a short while, in order to give upper-layer protocols a
chance to provide reachability confirmation.
• Probe — The neighbor is no longer known to be reachable, and
Unicast Neighbor Solicitation probes are being sent to verify
reachability.
– Router—Whether the neighbor is a router (Yes or NA).
2 To add a new IPv6 neighbor, click Edit, Add, and enter the fields:
– IPv6 Interface — Displays the interface on which the IPv6 address is
defined.
– IPv6 Address — Enter the neighbor IPv6 address.
– MAC Address — Enter the MAC address assigned to the interface.
3 To modify or remove an IPv6 neighbor, click Edit, and enter the fields
described above page.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 8 / 9 / 1 6 - F O R P R O O F O N L Y
Guide\Dell_Astute_SwitchManagement.fm
Switch Management
81