How To Configure The Own Ship Mark; How To Set Up A Secondary Monitor - Furuno FSV25 Installation Manual

3. POST INSTALLATION SETTINGS
3.6

How to Configure the Own Ship Mark

Set your ship's length and width and the position of the transducer, to accurately
display the own ship mark on the screen.
1. Access the system menu (See paragraph 3.4.1).
2. Select [Own Ship Mark] then left click.
3. Select [Ship's Length] then left click.
4. Use  or  to set length. The setting range is 15 to 150 m.
5. Set the [Ship's Width] and [TD Position 1 (or 2)] similarly.
• [Ship's Width]: The width of
the ship at its widest point. (Set-
ting range 5 to 30 m)
• [TD Position 1]: Distance from
transducer to bow. (Setting
range: 5 to 50 m)
• [TD Position 2]: Distance from
transducer to keel. Select [+] for
starboard, [-] for port. (Setting
range: -10 to 10 m)
6. Select [Quit] to apply the settings.
7. Long-press the MENU/ESC key to
close all menus.
3.7

How to Set Up a Secondary Monitor

When a secondary monitor is connected, use the following procedure to adjust the
display settings.
1. Access the system menu (See paragraph 3.4.1).
2. Select [Initial Settings], then left click.
3. Select [Monitor Settings], then left click.
4. Select [2nd Monitor Display], then left click.
5. Select [Dual Display] or [Sub Display] as appropriate, then left click.
[Dual Display]: When in Dual mode, each display can be assigned as Main or
Sub monitor.
[Sub Display]: Displays the same screen as the Main or Sub monitor
When there is no secondary monitor connected, set this option to [OFF].
6. Select [Quit] at the top-right of the Menu box, then left click.
7. Restart the unit (turn power OFF then ON) to apply the settings.
3-10
TD Position 1
TD Position 2
(Negative value
for port)
Ship's Width
Ship's
Length