Furuno FSV25 Installation Manual page 18

1. HOW TO INSTALL THE SYSTEM
Flush mount
1. Prepare a hole in the mounting location referring to outline drawing shown below.
4 - Pilot holes
2. Make four pilot holes for self-tapping screws (5).
3. Peel the tape from the Flush mount gasket then attach the gasket to the rear of
the control unit.
4. Set the unit to the hole and fasten it with self-tapping screws (520, 4 pcs.) and
wave washers.
5. Connect a ground wire (1.25 sq., local supply) between the ground terminal at the
bottom of the unit and ship's ground.
6. Set cosmetic caps to the fixing holes.
1.3.2 Control Unit FSV-853 (option)
Desktop installation, with keyboard fixture
Name
Keyboard fixture
Washer head screw
Rubber foot
1. Fix the keyboard fixture to the bottom of the unit with the screws (M412) supplied.
2. Attach rubber feet (2 pcs.) to the bottom of the unit.
3. Fix the unit to the mounting location with self-tapping screws (local supply).
1-10
351±1
Type
03-163-7821-1
M412 C2700W MBN12
M540
Keyboard fixture
340±0.5
Code No.
100-306-291-10
000-163-192-10
000-162-682-10
Rubber feet
Qty
1
6
2