Unpacking And Installation; Before Starting The Work; Unpacking The Machine - Canon iR C6800 Series Service Manual

Chapter 2
2.2 Unpacking and
Installation
2.2.1 Before Starting the
Work
Keep the following in mind when installing the
machine:
1. When a machine is moved from a cold to warm
location, condensation can occur in its pickup/feeding
assembly, ultimately causing image faults. As
necessary, leave the machine alone for at least 1 hour
without unpacking, and start the work when it has
fully become used to the room temperature.
(The term "condensation" refers to a symptom in
which droplets of water occur on the surface of a
metal object brought in from a cold to warm location
as the result of rapidly cooling vapor around it.)
2. The machine weighs about 230 kg. Be sure to work
in a group of 4 persons when lifting it.
3. Be sure to turn the 2 adjusters (front) found on the
bottom of the machine clockwise to release them.
These adjusters can slip off the machine when the
machine is moved. Take care not to lose them.
2-6
2.2.2 Unpacking the
1) Open the shipping box, and remove the plastic
covers.
2) Fit the 2 included grips [2] into the grip slots [1]
0002-6409
found on the pickup side of the machine.
F-2-6
3) While holding the grips on the pickup side (front,
rear), lift the machine slightly, and remove the pad [1]
in the direction of the arrow.
(weight of the machine: about 230 kg)
F-2-7
4) While holding the grips on the delivery side (front,
rear), lift the machine slightly, and remove the pad [1]
in the direction of the arrow.
At this time, do not lift the machine more than
necessary. Otherwise, you can lose the balance.
(weight of the machine: about 230 kg)
Machine
[1]
[2]
[1]
0002-6411
[2]