Appendix; Dos And Don'ts - Ricoh LW5100en Operating Instructions Manual

4. Appendix

This section describes Dos and Don'ts, the provided software and utilities CD-ROMs, specifications, and
paper.

Dos and Don'ts

The following items should be followed during use of this machine.
• Do not use flammable sprays or solvents in the vicinity of this machine. Doing so could result in
fire or electric shock.
• Unplug the power cord from the wall outlet before you move the machine. While moving the
machine, take care that the power cord is not damaged under the machine. Failing to take these
precautions could result in fire or electric shock.
• Do not turn the power off while the operation switch indicator is lit or blinking. Doing so may
damage the hard disk.
• Before unplugging the power cord or turning off the main power switch, make sure remaining
memory space is at 100%, as shown on the screen. See "Turning On/Off the Power".
• Do not touch areas on or around the fusing unit. These areas get hot.
• The area around the ventilation holes might feel warm. This is caused by exhaust air and is not a
malfunction.
• If the machine is moved from a cold to a warm place, condensation may form inside it. After
moving the machine, do not use it for at least an hour. The machine requires this time to adapt to its
new environment.
• The machine will malfunction if its internal temperature becomes too high. Be sure not to block the
intake and exhaust vents.
• Do not turn off the power while the machine is in operation. See "Turning On/Off the Power".
• Do not leave the main unit open for more than 10 minutes, otherwise image quality may
deteriorate.
• Do not open the covers of the machine when it is in operation. If you do, misfeeds might occur.
• Do not move or tilt the machine when the power is on.
• Do not allow small objects such as paperclips to fall into or become stuck inside the machine.
67