Trm 800V.2 Series Treadmill; Lubricants; Electrical Requirements - Precor TRM 885.v2 Service Manual

General Information

TRM 800v.2 Series Treadmill

This manual covers service information for the TRM 800 Series Treadmill.

Lubricants

 Do not apply any lubricants to the deck and belt. Do not use Wax Blast, silicon sprays, or other
applied lubricants. The use of these lubricants will quickly degrade the low-friction surface of the
deck.
 Do not use petroleum based lubricants on mechanical components such as the lift, as this may
result in degradation of nylon gearing mechanisms. Use only synthetic lubricants such as
"Super Lube with Teflon" or "Mobile One Synthetic" grease (RED).
NOTE Use of unapproved lubricants, cleaners, or solvents may void the treadmill warranty
:

Electrical Requirements

When your equipment is delivered you will receive an equipment power cable that meets your local
electrical code requirements. Precor treadmills must be connected to a 20 amp, individual branch
circuit that can be shared only with one PVS (Personal Viewing System) screen. If you need
additional help with the power connections contact your Precor authorized dealer.
IMPORTANT An individual branch circuit provides a hot conductor and neutral conductor to a
note
receptacle. The conductors must not be looped, "daisy-chained", or connected to
any other conductors or receptacles. The circuit must be grounded according to
NEC guidelines or local region electric codes..
Note: NEC (National Electric Code) guidelines or local region electric codes must be followed.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 7