Drive Belt Tension Adjustment - Precor TRM 885.v2 Service Manual

Adjustment Procedures
This section provides you with the step-by-step procedures required to make adjustments. Perform
the appropriate adjustment procedures when a trouble symptom points to a particular problem and
after removing and replacing major components. Refer to
instructions on how to disassemble and reassemble the running belt, deck, drive motor, rollers and
all associated parts.
Adjustment procedures::

Adjusting Drive Belt Tension

Tensioning the Running BeltError! Bookmark not defined.

Running Belt Tracking Adjustment

Calibrating the Lift Motor

Drive Belt Tension Adjustment

1. Set the treadmill circuit breaker in the off position and unplug the line cord from the wall outlet.
2. Remove the hood.
Note:
This procedure assumes that the drive belt has been installed and seated onto
the motor drive belt pulley and roller drive pulley.
3. Place the drive belt tension gauge on the drive belt as shown in Figure 32.
Figure 32: Drive Belt Tension Gauge
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Replacement Procedures for
Page 88