Installation And Removal Of Disk Drives In The Front Drive Bay - Siemens SIMATIC Rack PC 840 V2 Operating Instructions Manual

10.4.2

Installation and removal of disk drives in the front drive bay

Preparations
1. Unplug the device from mains and disconnect all cables.
2. Open the device.
Remove the front drive bay
How to remove the front drive bay
1
2
3
4
Disk drive or removable disk rack installation
Steps for installing a disk drive
1
2
3
4
SIMATIC Rack PC 840 V2
Operating Instructions, Edition 05/2006, A5E00248055-04
Loosen mounting screw (1);
remove mounting screw (2)
Disconnect the power cable and
the data cable from the installed
disk drives.
Lift the drive bay out of the device
until you can access the
connecting cables of the floppy
disk drive.
Disconnect these cables
Carefully remove the drive bay
from the device
Slide the disk drive into the bay
from the front
Mount the disk drive into the drive
bay using four screws
Reinstall the drive bay
Connect the power and data cables
to the disk drive.
Expansions and configuration
10.4 Installing disk drives
10-7