Siemens SIMATIC Rack PC 840 V2 Operating Instructions Manual page 74

Maintenance and service
11.2 Reinstalling the software
If your hard disk is not set up yet, select
2. Boot for FDISK, FORMAT or Windows Setup
5. Confirm the
SIEMENS End User License Agreement
by pressing F8. Press ESC to decline the agreement and to abort setup.
6. In the next screen form, select which components you want to copy from the CD to your
hard disk. Minimum requirement for your Windows NT installation or setup is a copy of the
"I386" folder.
7. Select the destination drive for data transfer. The selected drive is not the installation drive
for Windows. Windows Setup requires approximately 300 MB of free hard disk space on
your Windows installation drive.
Note
Drive C: is the default destination for the data transfer (Recovery).
Please note that drive C: must provide approximately 300 MB of free hard disk space after
the selected recovery data have been copied.
8. Acknowledge the end message.
9. Run Windows Setup with
<<DRIVE>>:\I386\Winnt.exe
<<DRIVE>> is the destination drive to which the Recovery were copied.
For information on Windows NT Setup, refer to the SUPPORT\BOOKS\ folder on your
Recovery CD.
Note
If you want to become an expert user of Microsoft Windows NT Workstation, see the
"Windows NT Workstation Technical Reference, Version 4.0 (not included in the package). It
contains specific information for system administrators who are responsible for installing,
managing, and integrating Windows NT Workstation in a network or multiuser environment.
11-20
Operating Instructions, Edition 05/2006, A5E00248055-04
SIMATIC Rack PC 840 V2