Siemens SIMATIC Rack PC 840 V2 Operating Instructions Manual page 78

Maintenance and service
11.2 Reinstalling the software
3. Select
CD-ROM drive
4. From the "Microsoft Windows 98 Startup Menu" screen form, select
1. Boot for CD Recovery
If your hard disk is not set up yet, select
2. Boot for FDISK, FORMAT or Windows Setup
5. Confirm the
SIEMENS End User License Agreement
by pressing F8. Press ESC to decline the agreement and to abort setup.
6. In the next screen form, select which components you want to copy from the CD to your
hard disk. Minimum requirement for your Windows XP installation or setup is a copy of the
"I386" folder.
7. Select the destination drive for data transfer. The selected drive is not the installation drive
for Windows. Windows Setup requires approximately 1500 MB of free hard disk space on
your Windows installation drive.
Note
Drive C: is the default destination for the data transfer (Recovery).
Please note that drive C: must provide approximately 1500 MB of free hard disk space after
the selected recovery data have been copied.
8. Confirm the end message.
9. Run Windows Setup with
<<DRIVE>>:\I386\Winnt.bat
<<DRIVE>> is the destination drive to which the Recovery were copied.
10. Now follow the instructions on the screen.
11-24
Operating Instructions, Edition 05/2006, A5E00248055-04
SIMATIC Rack PC 840 V2