Step 1.
Remove the screws securing the motor shroud
to the frame assembly, and lift the shroud off of
the frame assembly. Retain the screws for later
use when re-installing the motor shroud.
Note: Make sure the shroud is properly stored to
prevent damage.
Step 3.
Position neck close to the service opening in
the front of treadmill so the cables go into the
opening first.
7
INSTALLATION INSTRUCTIONS
Step 2.
Verify the cables are properly fed through at-
tached protective tube in the base of the neck.
Note: The tube will protect cables from getting
pinched during installation and will make it easier to
route them through service opening.
Step 4.
Route all cables from neck into motor compart-
ment through lower neck service opening.
Caution: Make sure not to pinch any cables.
600-7919 Rev A