Garmin G500 Reference Manual page 70

Avionics display systems

Hide thumbs Also See for G500:

Table of Contents

AUX GROUP

Selecting Temperature Reference

1) While viewing the System Setup page of the AUX page group, press the small

MFD knob to activate the cursor. Turn the large MFD knob to highlight the

desired Temp Reference value.

2) Turn the small MFD knob to select the Temp Reference type and press ENT

Synchronization

NOTE: SYNCHRONIZATION of the CDI and BARO will only be

available if a second GDU 620 is installed. DATABASES depend on

the installation configuration. CHART STREAMING only appears if

DATABASES is turned on.

1) While viewing the System Setup Page of the Aux Page Group, press the small

MFD knob and turn the large MFD knob to move to the desired field in the

SYNCHRONIZATION box.

2) Turn the small MFD knob to turn ON or OFF synchronization of the CDI. Turn

the large MFD knob to move to the BARO setting. Turn the small MFD knob

to turn the synchronization of the barometer ON or OFF. Turn the small MFD

knob to turn the synchronization of databases ON or OFF.

3) Press ENT to move to the DATE/TIME box or press the small MFD knob to

exit the editing mode.

Figure 3-44 Outside Air Temperature Selection

Synchronization Option

G500/G600 Cockpit Reference Guide

190-00601-03 Rev H

Table of Contents

G600