Specifying The Setpoint Via The Fieldbus - Siemens SINAMICS G120D Operating Instructions Manual

7.3.2

Specifying the setpoint via the fieldbus

Interconnecting the fieldbus with the main setpoint
Figure 7-8
Most standard telegrams receive the speed setpoint as a second process data PZD2.
Table 7- 3
Parameter
p1070 = 2050[1]
p1075 = 2050[1]
Converter with control units CU250D-2
Operating Instructions, 04/2015, FW V4.7.3, A5E34261542B AB
Fieldbus as setpoint source
Setting the fieldbus as setpoint source
Remark
Main setpoint
Interconnect the main setpoint with process data PZD2 from the fieldbus.
Additional setpoint
Interconnect the additional setpoint with process data PZD2 from the fieldbus.
Advanced commissioning
7.3 Setpoints
127