Activating Diagnostics Via The Control - Siemens SINAMICS G120D Operating Instructions Manual

Selecting a telegram
Procedure
Proceed as follows to set a specific telegram in the inverter:
Using STARTER or an operator panel, set parameter p0922 to the appropriate value.
You have set a specific telegram in the inverter.
6.3.6

Activating diagnostics via the control

The converter provides the functionality to transmit fault and alarm messages (diagnostic
messages) to the higher-level control according to the PROFIdrive error classes.
You must select the functionality in the higher-level control (see Manuals for your inverter
(Page 387)) and activate it by booting up.
Converter with control units CU250D-2
Operating Instructions, 04/2015, FW V4.7.3, A5E34261542B AB
Adapt fieldbus configuration
6.3 Communication via PROFINET
109