Restoring The Factory Default Settings - Sennheiser Flex 5000 Instruction Manual

1A

Restoring the factory default settings

To restore the transmitter to the factory settings:
1 Disconnect the transmitter from the power supply system by
unplugging the connector of the power supply unit.
2 Simultaneously press and hold the buttons L,
3 Connect the transmitter to the power supply system by connect-
ing the connector of the power supply unit to the yellow socket
of the transmitter while keeping the 3 buttons pressed for at
least 3 seconds.
All LEDs on the transmitter flash. The transmitter settings are
restored to the factory settings.
1
1A
To restore a receiver to the factory settings:
Place the receiver into the transmitter's charging compartment.
The Receiver status
receiver are also restored to the factory settings.
If you place the receiver into the transmitter's charging com-
partment at the very beginning of the restore procedure, the
factory settings of the transmitter and the receiver are
restored simultaneously.
Disconnect the transmitter from the power supply system by
unplugging the connector of the power supply unit.
The factory settings are restored and you can use the wireless
headphone system again.
Using additional functions
2
3
3s
LED flashes green. The settings of the
and R.
1A
Flex 5000 | 31