Displaying The Remaining Operating Time Of The Rechargeable Battery; Using The Charging Reminder Function - Sennheiser Flex 5000 Instruction Manual

Always store the receiver in the transmitter's charging com-
partment to ensure that it is fully charged when needed. The
intelligent battery charging technology prevents overcharg-
ing.
The display during charging can be set so that it automatically
switches off after 30 seconds (see page 29).
Displaying the remaining operating time of the
rechargeable battery
When you switch the receiver on, the Battery LED
remaining operating time/charge status.
Battery
LED
To indicate that the operating time is decreasing, each LED segment
slowly dims before it goes off completely.
If the actual operating time differs widely from the specified values,
the rechargeable battery is probably exhausted and should be
replaced. Information on the rechargeable battery can be found on
page 26.
The display of the remaining operating time can be set so that
it automatically switches off after 30 seconds (see page 29).
If more than one receiver is connected to the transmitter, the
remaining operating time/charge status cannot be displayed.

Using the charging reminder function

When the receiver is switched off and the transmitter automatically
switches off (standby mode), the
forth for 10 minutes to remind you to charge the receiver.
Charge the receiver by placing it into the transmitter's charging
compartment (see page 16).
The LED stops flashing and the charging process starts.
You can also switch off the charging reminder function (see
page 29).
Putting the Flex 5000 into operation
Meaning
Battery
LED Rechargeable battery
flashes slowly is empty; recharge it
st
approx. 4 hours of
1 LED segment
operating time
lit
st nd
approx. 8 hours of
1 + 2 LED
operating time
segments lit
All LED approx. 12 hours of
segments lit operating time
Battery
LED will flash back and
displays the
Flex 5000 | 17