Using Additional Functions; Pairing One Or Several Receivers With The Transmitter - Sennheiser Flex 5000 Instruction Manual

1...4

Using additional functions

The following additional functions are not required for normal use
of the wireless headphone system. You can, however, extend the
potential use of the system and adjust some of the functions to
your individual needs.

Pairing one or several receivers with the transmitter

The receiver and the transmitter of your wireless headphone
system are factory pre-paired. The following steps are only neces-
sary if you want to pair additional receivers with the transmitter.
You can simultaneously use up to 4 paired receivers with your trans-
mitter. All other paired and switched-on receivers cannot connect to
the transmitter.
If more than one receiver is connected to the transmitter, the
remaining operating time/charge status and the hearing pro-
file cannot be displayed. In addition, the balance and a hearing
profile cannot be adjusted. These functions can only be used/
adjusted when only one receiver is connected to the transmit-
ter.
Option A (contact pairing)
Place the receiver into the transmitter's charging compartment.
The receiver is paired with the transmitter.
1...4
Option B (proximity pairing)
1 Place the receiver as close as possible to the transmitter.
2 Simultaneously press and hold the volume buttons
Receiver status
LED flashes red. Once paring is completed, the
Receiver status LED flashes green and the
flashes white.
Release the buttons.
1 2
Using additional functions
+/– until the
Transmitter status LED
Flex 5000 | 27