Switching The Wireless Headphone System Off; Attaching The Receiver To Clothing - Sennheiser Flex 5000 Instruction Manual

Using the Flex 5000
OFF
2s
LED goes off
20 | Flex 5000

Switching the wireless headphone system off

Place the receiver into the transmitter's charging compartment.
The receiver switches off. The
charging process starts (see page 16).
Or, if you want to switch the receiver off without placing it into the
transmitter's charging compartment:
Speech intelligibility
Press the
The receiver switches off. The
The transmitter automatically switches off (standby) when
there is no receiver connected. The
off.
Always store the receiver in the transmitter's charging com-
partment to ensure that it is fully charged when needed.
If the receiver is outside the transmission range for more than
5 minutes or if the transmitter receives no audio signal for
more than 30 minutes, the wireless headphone system
switches off automatically (standby).
To disconnect the transmitter from the power supply system (e.g.
when you are on holiday):
Unplug the power supply unit from the wall socket.

Attaching the receiver to clothing

Depending on the connected headphones or induction loop, please
observe the following attachment recommendations for your
receiver:
• Place the receiver next to you
so that you can take it in your
hand and operate it.
• Use the clip to attach the
receiver to your clothing. Make
sure that the headphone cable
does not hinder your move-
ments and that there is a free
line of sight between the
receiver and the transmitter.
The volume buttons face away
from your body to facilitate
ease of use.
• Place the induction loop around
your neck so that the receiver
rests on your chest. The volume
buttons face away from your
body to facilitate ease of use.
Receiver status
LED goes off. The
button for 2 seconds.
Receiver status
LED goes off.
Transmitter status
LED goes