Panasonic KX-NS1000 Feature Manual page 59

g.
When using a sub extension in wireless XDP parallel mode (® 22.1.6 Wireless XDP Parallel Mode).
•
This feature stops when the busy extension user presses the following buttons during a conversation (®
7.1.1 Fixed Buttons, ® 7.1.3 Flexible Buttons):
–
FLASH/RECALL button
–
HOLD button
–
TRANSFER button
–
CONF (Conference) button
–
DSS button
–
EFA button
–
Two-way Record button
–
Two-way Transfer button
–
One-touch Two-way Transfer button
–
Voice Mail (VM) Transfer button
•
Monitoring a Call that is Being Recorded
When a user monitors a call that is being recorded, the user's voice will not be recorded. When an intercom
call is being recorded, call monitoring can be performed on either extension.
Executive Busy Override can also be performed on a call that is being recorded. In this case, the user's
voice will be recorded.
When a member of the original call leaves the conference created by Executive Busy Override, recording
will stop and the remaining extensions will operate as follows:
–
If Automatic Two-way Recording for Manager has been set, recording will start again according to those
settings.
–
If Automatic Two-way Recording for Manager has not been set, one of the parties can press the
Two-way Record button to start a new recording.
A call being recorded between 2 extensions cannot be monitored if the user performing Call Monitoring is
connected via QSIG (TIE).
•
Monitoring a Conference
When a user monitors a three-party conference, the voices of all 3 participants can be heard.
Executive Busy Override can also be performed on a three-party conference. In this case, a four-party
conference will be established.
Call monitoring cannot be performed on a conference on hold.
Call monitoring cannot be performed on a three-party conference where the originator of the conference
is on an outside line (e.g., when calling from a cellular phone).
A 3-party conference call cannot be monitored if the user performing Call Monitoring is connected via QSIG
(TIE).
PC Programming Manual References
10.6.3 PBX Configuration—[2-6-3] System—Numbering Plan—B/NA DND Call Feature—
10.7.1 PBX Configuration—[2-7-1] System—Class of Service—COS Settings—Executive—
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
→Option 2— Data Mode
→Option 3— Executive Override Deny
12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings—Option 3—
Override Deny
Feature Manual References
4.1.18 Conference
4.1.22 COS (Class of Service)
20.1.9 Unified Messaging—Automatic Two-way Recording for Manager
20.1.90 Unified Messaging—Two-way Record/Two-way Transfer
Document Version 2016-03
4.1.6 Call Monitor
Call Monitor
Call Monitor
Executive
Feature Manual 59