Panasonic KX-NS1000 Feature Manual page 52

4.1.3 Caller ID
[Programming Example: System Speed Dialing Table]
Location
(System Speed
Dialing No.)
000
001
® 14.1 PBX Configuration—[6-1] Feature—System Speed Dial—
*1
® 14.1 PBX Configuration—[6-1] Feature—System Speed Dial—
*2
® 14.1 PBX Configuration—[6-1] Feature—System Speed Dial—
*3
5.
Displaying the Caller's Name
In addition to the System Speed Dialing Table, each extension can store names and numbers in Personal
Speed Dialing. Therefore, it is entirely possible for the same telephone number to be stored under a
different name in different locations within the PBX.
When a call containing Caller ID information is received, the PBX will search for the caller's name in the
following order, then show that name on the display and log it via SMDR.
1.
Personal Speed Dialing data of the extension which received the call
2.
System Speed Dialing Table
3.
The Caller ID information received from the telephone company
If a caller's name is not stored in the PBX or sent from the telephone company, it will not be displayed or
logged.
Conditions
[General]
•
Caller ID signaling type can be selected through system programming.
[Caller ID to SLT Port]
•
Hardware Requirement:
An LCOT2+SLC2 or PRI23+SLC2 card
For details about the hardware requirements for a legacy gateway (® 18.1.11 Stacking Connection), refer
to the documentation of the legacy gateway.
•
When the caller's number is sent to an SLT, a CO Line Access number can be automatically added to the
telephone number through system programming for calling back.
•
For SLC-type cards, you can set the "Ringing Start Mode of Extension Caller ID" setting as follows.
–
Mode 1: Enables pre-ringing. Pre-ringing control is performed when a call with caller ID information is
received. Even if pre-ringing is enabled, the FSK signal is sent between the first and second rings.
–
Mode 2: Disables pre-ringing (caller ID information is sent after the first ring).
Changes to this setting are effective immediately. For more information, refer to the documentation of the
legacy gateway.
•
When the caller's number exceeds 16 digits, the SLT receives only the first 16 digits, not counting the
preceding CO Line Access number (if it is programmed to be added).
•
If a call is transferred to an SLT, the transferring extension's information will be shown on the SLT. If the
transferring extension goes on-hook before the call is answered, the original caller's information will be
shown.
•
When Caller ID information such as "Private", "Out of Area", or "Long Distance" is received, this information
will be shown instead of the caller's number and name.
•
Even if the caller's name is sent, the name may not be shown depending on the type of SLT.
•
Incoming Call Log information is not shown on the SLT.
52 Feature Manual
System Speed
Telephone No.
Dialing Name
*1
ABC Company 912125551234
XYZ Company 913135551234
CLI Destination
*2 *3
200
300
CO Line Access Number + Telephone Number
Name
CLI Destination
Document Version 2016-03