Panasonic KX-NS1000 Feature Manual page 219

Button
Call Park
*1 This feature is not controlled from the PBX.
Not available on all KX-UT series SIP phones.
*2
Conditions
•
Requirement:
A V-UTEXT card is required to use a KX-UT series SIP phone.
•
Changes made locally to entries downloaded from the PBX are not applied to the phonebook entries on
the PBX.
•
Only entries in the PBX directories that have phone numbers assigned will be downloaded.
•
On KX-UT248 and KX-UT670 phones, the labels displayed on flexible buttons can be customized through
system programming.
® 12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button—
•
Incoming/Outgoing call log information is stored on the phone, not on the PBX.
•
Automatic Rerouting to Secondary PBX
A KX-UT series SIP phone can automatically connect to a secondary PBX if its primary PBX goes offline.
When the primary PBX is available again, the phone reconnects to it. (® 2.1.7 Automatic Rerouting to
Secondary PBX)
•
For detailed explanations about a particular KX-UT series SIP phone, refer to the telephone's
documentation.
•
DSP Resource Usage
Making a call from a SIP extension requires a certain number of DSP resources, depending on the codec
used. If all DSP resources are in use, this operation cannot be performed. To ensure a minimum level of
performance, DSP resources can be reserved for VoIP communication. (® 5.1.18 DSP Resource
Usage)
However, DSP resources are not required for P2P calls. (® 15.1.5 Peer-to-Peer (P2P) Connection)
Installation Manual References
4.4 Virtual Cards
PC Programming Manual References
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property—
UT Extensions
9.5.1 PBX Configuration—[1-1] Configuration—Slot—Site Property—Main—Main—
Mode
9.20 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Card Property
9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
14.1 PBX Configuration—[6-1] Feature—System Speed Dial—
Document Version 2016-03
Place the current call into a parking zone of the PBX. (® 4.1.7 Call Park)
There are two modes:
•
Specific: Place the call into the specified park zone.
•
Automatic: The telephone searches for an idle park zone from among
those assigned to its own flexible buttons.
11.1.1 KX-UT Series SIP Phones
Usage
System Speed Dial Download For
IP Terminal Registration
Memory
Feature Manual
Label Name
219