HP MSR2000 Configuration Manual page 358

Change the configuration to meet non-FIPS mode requirements, save the configuration to
the next-startup configuration file, and then reboot to enter non-FIPS mode.
# Set the authentication mode for VTY lines to scheme.
[Sysname] line vty 0 4
[Sysname-line-vty0-4] authentication-mode scheme
# Save the current configuration to the root directory of the storage medium, and specify it as the startup
configuration file.
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[cfa0:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
cfa0:/startup.cfg exists, overwrite? [Y/N]:y
Validating file. Please wait...
Saved the current configuration to device successfully.
[Sysname] quit
# Delete the startup configuration file in binary format.
<Sysname> delete cfa0:/startup.mdb
Delete cfa0:/startup.mdb?[Y/N]:y
Deleting file cfa0:/startup.mdb...Done.
# Reboot the device.
<Sysname> reboot
Verifying the configuration
After the device reboots, enter the username test and password 12345zxcvb!@#$%ZXCVB to enter
non-FIPS mode.
Press ENTER to get started.
login: test
Password:
Last successfully login time:...
...
<Sysname>
# Display the current FIPS mode state.
<Sysname> display fips status
FIPS mode is disabled.
347