HP MSR2000 Configuration Manual page 203

# Reference IPsec transform set tran1 for the IPsec policy.
[DeviceA-ipsec-policy-isakmp-map1-10] transform-set tran1
# Specify IKE profile profile1 for the IPsec policy.
[DeviceA-ipsec-policy-isakmp-map1-10] ike-profile profile1
[DeviceA-ipsec-policy-isakmp-map1-10] quit
# Apply IPsec policy map1 to interface Ethernet 1/1.
[DeviceA-Ethernet1/1] ipsec apply policy map1
[DeviceA-Ethernet1/1] quit
# Configure a static route to subnet 10.1.2.0/24.
[DeviceA] ip route-static 10.1.2.0 255.255.255.0 2.2.2.2
2. Configure Device B:
# Assign IP addresses to each interface. (Details not shown.)
# Configure ACL 3101 to identify traffic from subnet 10.1.2.0/24 to subnet 10.1.1.0/24.
<DeviceB> system-view
[DeviceB] acl number 3101
[DeviceB-acl-adv-3101] rule permit ip source 10.1.2.0 0.0.0.255 destination 10.1.1.0
0.0.0.255
[DeviceB-acl-adv-3101] quit
# Create an IPsec transform set named tran1.
[DeviceB] ipsec transform-set tran1
# Set the packet encapsulation mode to tunnel.
[DeviceB-ipsec-transform-set-tran1] encapsulation-mode tunnel
# Use the ESP protocol for the IPsec transform set.
[DeviceB-ipsec-transform-set-tran1] protocol esp
# Specify the encryption and authentication algorithms.
[DeviceB-ipsec-transform-set-tran1] esp encryption-algorithm aes-cbc-128
[DeviceB-ipsec-transform-set-tran1] esp authentication-algorithm sha1
[DeviceB-ipsec-transform-set-tran1] quit
# Create and IKE keychain named keychain1.
[DeviceB]ike keychain keychain1
# Specify plaintext 123456TESTplat&! as the pre-shared key to be used with the remote peer at
1.1.1.1.
[DeviceB-ike-keychain-keychain1] pre-shared-key address 1.1.1.1 255.255.255.0 key
simple 123456TESTplat&!
[DeviceB-ike-keychain-keychain1] quit
# Create an IPsec policy named use1, with the sequence number as 10 and the IPsec SA setup
mode as IKE.
[DeviceB] ipsec policy use1 10 isakmp
# Specify the remote IP address 1.1.1.1 for the IPsec tunnel.
[DeviceB-ipsec-policy-isakmp-use1-10] remote-address 1.1.1.1
# Reference ACL 3101 to identify the traffic to be protected.
[DeviceB-ipsec-policy-isakmp-use1-10] security acl 3101
# Reference IPsec transform set tran1 for the IPsec policy.
[DeviceB-ipsec-policy-isakmp-use1-10] transform-set tran1
# Specify IKE profile profile1 for the IPsec policy.
192