Configuring Portal Web Server Detection - HP MSR2000 Configuration Manual

If the portal authentication server receives a portal packet within a detection timeout (timeout timeout)
and the portal packet is valid, the device considers the detection succeeds and the portal authentication
server is reachable. Otherwise, the device considers the detection fails and the portal authentication
server is unreachable.
You can configure the device to take one or more of the following actions when the server reachability
status changes:
Sending a log message, which contains the name, the current state, and the original state of the
•
portal authentication server.
Enabling portal fail-permit. When the portal authentication server is unreachable, the portal
•
fail-permit feature on an interface allows users on the interface to have network access. When the
server recovers, it resumes portal authentication on the interface. For more information, see
"Configuring the portal fail-permit
Portal packets include user login packets, user logout packets, and heartbeat packets. Only the IMC
portal authentication server supports the heartbeat packet detection. To test server reachability by
detecting heartbeat packets, you must enable the server heartbeat function on the IMC portal
authentication server.
To configure the portal authentication server detection function:
Step
1. Enter system view.
2. Enter portal
authentication server
view.
3. Configure the portal
authentication server
detection function.

Configuring portal Web server detection

A portal authentication process cannot complete if the communication between the access device and
the portal Web server is broken. To address this problem, you can enable portal Web server detection
on the access device.
With the portal Web server detection function, the access device simulates a Web access process to
initiate a TCP connection to the portal Web server. If the TCP connection can be established successfully,
the access device considers the detection succeeds and the portal Web server is reachable. Otherwise,
it considers the detection fails.
You can configure the following detection parameters:
Detection interval—Interval at which the device detects the server reachability.
•
• Maximum number of consecutive failures—If the number of consecutive detection failures reaches
this value, the access device considers that the portal Web server is unreachable.
You can configure the device to take one or more of the following actions when the server reachability
status changes:
function."
Command
system-view
portal server server-name
server-detect [ timeout timeout ] log
307
Remarks
N/A-
N/A
By default, portal authentication
server detection is disabled.
This function takes effect
regardless of whether portal
authentication is enabled on an
interface or not.