TP-Link TL-WR902AC User Manual page 47

Chapter 4
broadcast or multicast messages for associated clients, it sends the next DTIM with a
DTIM Interval value. You can specify the value between 1-255 Beacon Intervals. The
default value is 1, which indicates the DTIM Interval is the same as Beacon Interval.
• Enable WMM - WMM function can guarantee the packets with high-priority messages
being transmitted preferentially. It is strongly recommended to enable this function.
• Enable Short GI - It is recommended to enable this function, for it will increase the
data capacity by reducing the guard interval time.
• Enable AP Isolation
wireless stations cannot access each other through WLAN. This function will be
disabled if WDS/Bridge is enabled.
4. 3. 6. Wireless Statistics
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to Advanced
sent and received by each client device connected to the router.
• MAC Address - The MAC address of the connected wireless client.
• Current Status - The running status of the connected wireless client.
• Received Packets - Packets received by the wireless client.
• Sent Packets - Packets sent by the wireless client.
• Configure - The button is used for loading the item to the Wireless MAC Filtering list.
• Allow - If the Wireless MAC Filtering function is enabled, click this button to
allow the client to access your network.
• Deny - If the Wireless MAC Filtering function is enabled, click this button to
deny the client to access your network.
- This function isolates all connected wireless stations so that
> Wireless 2.4GHz >
Configure the Router in Standard Router Mode
Wireless Statistics to check the data packets
44