TP-Link TL-WR902AC User Manual page 121

Chapter 5
¾ To access the USB disk locally:
1. Connect Your USB Disk
Insert your USB storage device into the router's USB port directly or using a USB cable.
Wait several seconds until the USB LED becomes solid on.
Tips:
• If you use USB hubs, make sure no more than 2 devices are connected to the router.
• If the USB storage device requires using bundled external power, make sure the external power has been
connected.
• If you use a USB hard drive, make sure its file system is FAT32 or NTFS.
• Before you physically disconnect a USB device from the router, safely remove it to avoid data damage: Go to
Advanced > USB Settings
2. Access Your USB Disk Locally
Refer to the following table for access instructions. You can customize user accounts by
referring to User Accounts.
Open the
address
password and then press [Enter].
Note:
Here we take Windows 8 as an example.
Windows
computer
> Storage Sharing and click
Windows Explorer
ftp://tplinkwifi.net in the address bar, enter a username and
Configure the Router in Hotspot Router Mode
Eject Disk.
(or go to Computer), type the server
118