TP-Link TL-WR902AC User Manual page 195

Chapter 7
• DHCP Server - Enable or disable the DHCP server. If disabled, you must have another
DHCP server within your network or else you must configure the computer manually.
• Start IP Address - Specify an IP address for the DHCP Server to start with when
assigning IP addresses. 192.168.0.100 is the default start address.
• End IP Address - Specify an IP address for the DHCP Server to end with when assigning
IP addresses. 192.168.0.199 is the default end address.
• Address Lease Time
will be allowed to connect to the router with the current dynamic IP Address. When
time is up, the current dynamic IP will be automatically renewed. The range of the
time is 1 ~ 2880 minutes. The default value is 1.
• Default Gateway (Optional)
the router. The default value is 192.168.0.1.
• Default Domain (Optional)
• Primary DNS (Optional)
• Secondary DNS (Optional)
provides two DNS servers.
Note:
• To use the DHCP server function of the router, you must configure all computers on the LAN as
Address automatically.
• When you choose Dynamic IP(DHCP)
will see the page as below.
- The Address Lease Time is the amount of time a network user
- It is suggested to input the IP address of the LAN port of
- Input the domain name of your network.
- Input the DNS IP address provided by your ISP.
- Input the IP address of another DNS server if your ISP
in Setting > Network
Configure the Router in Range Extender Mode
> LAN, the DHCP Server function will be disabled. You
Obtain an IP
192