Table of Contents
Advertisement
(1) Connector Communication
Connector communication can be performed by selecting either an RS-232C
connection or USB connection depending on the host computer interface.
Connect the host computer and BHT with a dedicated interface cable and perform
data communication.
Requests
Do not use a cable other than the dedicated interface cable.
Avoid inserting the connector at an angle or pulling the cable strongly.
Place the BHT on the communication unit (CU-733, CU-714) and transmit data.
Requests
Handling the CU-714
A Category 5 (Cat 5) LAN cable or higher is required when using the CU-714 in
100BASE-TX networks.
cables.
Do not forcibly insert the LAN connector or pull the cable strongly. Failure to observe this
may result in damage to the connector or cable.
The MAC address is written on the nameplate on the rear of the CU-714.
Dedicated interface
cable
CU-733: RS232C or USB
CU-714: Ethernet
Successful communication may not be possible with other
36
Transmitting Data
Advertisement
Table of Contents
