X542: Relay Outputs; Table 3-20 Terminal Block X524; Table 3-21 Description Of The Leds On The Tm31 - Siemens SINAMICS S120 Equipment Manual

Additional System Components
3.3 Terminal Module 31 (TM31)
3.3.3.12

X542: Relay outputs

Table 3-20 Terminal block X524
Terminal
1
2
3
4
5
6
Max. connectable cross-section. 2.5 mm
Type: Screw terminal 3 (see Appendix A)
1) DO: digital output, NO: normally-open contact, NC: normally-closed contact, COM: mid-position contact
3.3.3.13 Description of the LEDs on the Terminal Module 31 (TM31)
Table 3-21 Description of the LEDs on the TM31
LED Color
-
Green
Orange
READY
Red
Green
Red
Green/
Orange
or
Red/ Orange
Cause and rectification of faults
The following reference contains information about the cause and rectification of faults:
Reference: /IH1/ SINAMICS S, Commissioning Manual
3-24
Name
1)
DO 0.NC
DO 0.COM
DO 0.NO
DO 1.NC
DO 1.COM
DO 1.NO
2
State Description
OFF Electronics power supply outside permissible tolerance range.
Continuous The component is ready for operation and cyclic DRIVE-CLiQ
communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
Continuous At least one fault is present in this component.
Flashing Firmware is being downloaded.
2 Hz
Flashing Component recognition via LED is activated (p0154).
2 Hz
Note:
both options depend on the LED status when module recognition is
activated via p0154 = 1.
Technical specifications
Contact type: Two-way contact max. load current: 8 A
Max. switching voltage: 250 V
power at 250 V : 2000 VA (cosϕ = 1)
AC
Max. switching power at 250 V
Max. switching power at 30 V
Required minimum current: 100 mA
Overvoltage category: Class III to EN 60 664-1
Equipment Manual Control Units and Additional System Components
Equipment Manual, (GH1), 12/2004 Edition, 6SL3097-2AH00-0BP1
, 30V max. switching
AC DC
750 VA (cosϕ = 0.4)
AC:
: 240 W (ohmic load)
DC