Audi A8 Service Manual page 74

Audi A8 2003 ➤
Body Repairs - Edition 05.2011
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Preparing joints for adhesive application
– Take off roof side member and prepare flanges on body and
roof side member for bonding.
– Clean bonding area with silicone remover - LSE 020 100 A3- .
– Prepare bonding area with silicate stone -DA 009 800 - and
clean.
– Apply aluminium primer -DA 009 801 - to bonding surfaces
using applicator -D 009 500 25 - .
– Operate double cartridge gun -VAS 6453- with 2-component
epoxy adhesive -DA 180 A00 A2- and apply an approx.
100 mm long adhesive bead to a piece of cardboard before
starting application on the B-pillar.
Riveting in
– Rivet in roof side member using rechargeable riveter -VAS
5279A- .
Use rechargeable riveter -VAS 5279A- with attachments S2 and
S3 from -VAS 5279/2 - or rechargeable riveter -VAS 5279B- with
attachments S2 and S3 .
70
Rep. gr.51 - Body - centre
with respect to the correctness of information in this document. Copyright by AUDI AG.