Audi A8 Service Manual page 101

Replacement parts
♦ Rear cross panel
♦ Pop rivets
♦ Silicone remover -LSE 020 100 A3-
♦ 2-component epoxy adhesive -DA 001 730 A2-
– Match up new parts.
Note
Check dimensional accuracy with respect to rear lid.
Preparing joints for adhesive application
– Clean bonding area with silicone remover - LSE 020 100 A3- .
– Prepare bonding area with silicate stone -DA 009 800 - and
clean.
– Apply aluminium primer -DA 009 801 - to bonding surfaces
using applicator -D 009 500 25 - .
– Apply 2-component epoxy adhesive -DA 001 730 A2- to entire
riveting area using pneumatic glue gun -V.A.G 2005 B- .
– Insert rear cross panel.
Riveting in
– Rivet in rear cross panel using pop rivet pliers -VAS 5072- .
Body Repairs - Edition 05.2011
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A8 2003 ➤
1. Rear cross panel - Renewal
97