Program Example Written Without Using Gx Configurator-Tc; Set Value Write Command - Mitsubishi Electric MELSECSystem Q User Manual

6 PROGRAMMING

6.3 Program Example Written without Using GX Configurator-TC

Turned off in setting mode, turned on in operation mode.
Operation
mode setting
command

Set value write command

Set value write
command
Unused channel setting
Setting of input range and alert 1 mode
Setting of alert set value, set value and upper/lower setting limiter
Request to write to E PROM
Cancel of request to write to E PROM
2
E PROM write
completion flag
Needed when registering the set input range, alert setting, set value and others to E PROM.
Write to E PROM is not needed when using GX Configurator-TC's initial setting or writing
the input range, alert setting, set value and others using sequence program at power-on.
6 - 5
Setting change
command
Module Hardware
ready error flag
flag
Module Hardware Setting/
ready error flag operation
flag mode
command
2
Module Hardware Setting/
ready error flag change
flag completion
flag
2
2
Setting change
completion flag
MELSEC-Q
Setting/operation
mode command
Setting change
command
Setting change
command
2
E PROM
backup
command
2
E PROM
backup
command
2
6 - 5