Table of Contents
Advertisement
7 ONLINE MODULE CHANGE
7.3.2 Sequence program was used for initial setting
7 - 8
(1) Conversion disable
(a)
Turn off the following output signals to stop module operation.
Device No.
Yn1
Yn8
Yn9
YnB
POINT
Control may not stop if only the setting/operation mode command (Yn1) is turned off.
To stop control without fail, set the PID continuation flag (buffer memory address
A9H: Un*G169) for 0 (stop) and turn off the setting/operation mode command (Yn1).
To confirm that control has stopped, make sure that the setting/operation mode
status (Xn1) is off.
(b)
If the buffer memory contents to be saved are not yet prerecorded, choose
"Online" - "Monitor" - "" on GX Developer to monitor the buffer memory and
record the values.
POINT
If a CPU continuation error (e.g. SP. UNIT DOWN, UNIT VERIFY ERR.) has
occurred due to the fault of the module to be changed, the buffer memory contents
cannot be saved.
Signal name
Setting/operation mode command
2
E
PROM backup command
Default setting registration command
Setting change command
MELSEC-Q
7 - 8
Advertisement
Table of Contents
