Replacing An Sd Vflash Card - Dell poweredge T430 Owner's Manual

Next steps
1. Reconnect all the cables to the iDRAC port card.
2. Install the internal cooling fan.
3. Install the cooling shroud.
4. Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing the cooling shroud
Removing the internal cooling fan
Installing the cooling shroud
Installing the internal cooling fan
Removing the iDRAC port card
After working inside your system

Replacing an SD vFlash card

Prerequisites
NOTE: This procedure applies only to the eight hard drive system.
Steps
1. Locate the vFlash media slot on the system.
2. To remove the installed SD vFlash card, push inward on the card to release it and pull the card from
the card slot.
Figure 72. Removing the SD vFlash card
1. SD vFlash card
3. To install the SD vFlash card, with the label side facing up, insert the contact-pin end of the SD card
into the card slot on the module.
NOTE: The slot is keyed to ensure correct insertion of the card.
4. Press inward on the card to lock it into the slot.
160
2. SD vFlash card slot