Dell poweredge T430 Owner's Manual page 65

Option Description
Logical Processor Enables you to improve the energy efficiency of a system. It uses the operating
Idling system core parking algorithm and parks some of the logical processors in the
system which in turn allows the corresponding processor cores to transition into a
lower power idle state. This option can only be enabled if the operating system
supports it. It is set to Disabled by default.
Configurable TDP Enables you to reconfigure the processor Thermal Design Power (TDP) levels
during POST based on the power and thermal delivery capabilities of the system.
TDP verifies the maximum heat the cooling system is needed to dissipate. This
option is set to Nominal by default.
X2Apic Mode Enables or disables the X2Apic mode.
Dell Controlled Controls the turbo engagement. Enable this option only when System Profile is set
Turbo to Performance.
Number of Cores Controls the number of enabled cores in each processor. This option is set to All
per Processor by default.
Processor 64-bit Specifies if the processor(s) support 64-bit extensions.
Support
Processor Core Specifies the maximum core frequency of the processor.
Speed
Processor 1
The following settings are displayed for each processor installed in the system:
Option
Family-Model-
Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores
Related links
Processor Settings
Viewing Processor Settings
SATA Settings
You can use the SATA Settings screen to view the SATA settings of SATA devices and enable RAID on
your system.
NOTE: This option is only available on certain stock keeping units (SKUs) of the
processors.
NOTE: Depending on the number of installed CPUs, there may be up to four
processor listings.
NOTE: Depending on the number of CPUs, there may be up to four
processors listed.
Description
Specifies the family, model, and stepping of the processor
as defined by Intel.
Specifies the brand name.
Specifies the total L2 cache.
Specifies the total L3 cache.
Specifies the number of cores per processor.
65