Dell poweredge T430 Owner's Manual page 155

Figure 68. Removing a GPU card
1. expansion card latch (2)
3. SLI data connector
5. GPU card power connector
Next steps
1. Install the filler brackets by performing the following steps:
a. Align the slot on the filler bracket with the guide pin on the expansion card slot.
b. Press the expansion card latch until the filler bracket locks into place.
NOTE: Filler brackets must be installed over empty expansion-card slots to maintain FCC
certification of the system. The brackets also keep dust and dirt out of the system and aid
in proper cooling and airflow inside the system.
2. Close the two expansion card latches.
3. Replace the expansion card holder.
4. Install the cooling shroud.
5. Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing the cooling shroud
Removing the expansion card holder
Installing an optional GPU card
After working inside your system
2. GPU card
4. GPU card power connector
6. x16 connector
155