Removing The Power Supply Unit Blank - Dell poweredge T430 Owner's Manual

Figure 84. Installing a redundant PSU
1. release latch
3. PSU
5. PSU handle
Next steps
1. If you have unlatched the cable management arm, relatch it. For information about the cable
management arm, see the rack documentation of the system.
2. Connect the power cable to the PSU and plug the cable into a power outlet.
CAUTION: When connecting the power cable, secure the cable with the strap.
NOTE: When installing, hot-swapping, or hot-adding a new PSU in a system with two PSUs,
allow several seconds for the system to recognize the PSU and determine its status. The PSU
status indicator turns green to signify that the PSU is functioning properly.
Related links
Safety instructions

Removing the power supply unit blank

Removing a redundant AC power supply unit
Removing the power supply unit blank
Install the power supply unit (PSU) blank only in the second PSU bay.
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Follow the safety guidelines listed in the Safety instructions section.
Steps
If you are installing a second power supply unit (PSU), remove the PSU blank in the bay by pulling the
blank outward.
2. PSU cable connector
4. power connector
177