Turbine; Gearbox - Saeco Aulika Sup 040R Service Manual

AULIKA 07 DISASSEMBLY

7.10. Turbine

to replace the turbine, loosen the screws inside
the brewing unit niche shown in the picture

7.11. Gearbox

Loosen the screws shown in the picture and remove the
gearbox assembly
A
E
C
B
Inside the compartment protected by the casing there are:
- the electric motor (A) with the gears (B) and (C) that
operate the gearbox and the timing of the brewing unit.
- The Microswitch (D) intercepting both the idle phase and
B
D
the execution phase of the brewing unit.
- Slide out the big gear (B)
- Slide out the gear(C) that meshes with the drive
shaft of the motor
- Remove the motor (A) together with its drive shaft (E)
When reassembling the
gear (B), pay attention
that the arrow sign is
in the same position as
shown in the picture
to replace the turbine, loosen the screws inside
the brewing unit niche shown in the picture
When reassembling the motor and
drive shaft, pay attention that the
tracks (L) are slid back in their
proper seats. Grease the drive shaft
abundantly and uniformly.
Rev. 00 / July 2012
Loosen the screws shown in the
picture and remove the gearbox lid
L
Page / 09
05