Saeco Aulika Sup 040R Service Manual page 31

AULIKA
Description of the individual pages
SECTOR TYPE
Swiss
FUNCTION
Pow Off
FUNCTION
W.Net S
FUNCTION
W.Net A
FUNCTION
Debug
FUNCTION
ESC
FUNCTION
f
INFO
MV: xx
INFO
xx.yy.zz
INFO
B2B
INFO
B2B RI
INFO
DF
INFO
ER
INFO
Swiss
W.Net S
f MV: xx
B2B B2B RI
Swiss can be used to activate or deactivate the ECO-MODE default setting.
If Swiss is active, the Eco-Mode default setting is ON, while if Swiss is inac-
tive, the Eco-Mode default setting is OFF.
The hydraulic circuit emptying function brings the ECO-MODE back to the
default value. This default value, as already mentioned, is a function of the
Swiss setting
It shows whether the machine, once turned on with the electromechanical
switch (I/O), goes in Stand-By mode; if so, the "Pow Off" words are hi-
ghlighted. If it is deactivated, the machine does not go to Stand-By mode
immediately after the Power On.
If pressed, this key enables/disables the water net system function (if it is
active, then the machine is model B2B RI, if it is inactive, then the model is
B2B).
If pressed, it operates the 24VDC solenoid valve of the water network
system (actual activation occurs only if: - the grounds drawer and the brew
unit niche drawer are assembled and the side door is closed)
If selected, a debug window opens in user mode
If pressed, the machine exits Test Mode
Shows the network frequency. It can take the following values:
50 Hz
60 Hz
ERR when the frequency cannot be identified
shows the EEPROM Memory version
shows the version of the loaded software
If active, it shows that the machine version is B2B
If active, it shows that the machine version is B2B connected to the water
supply system.
Gives information of the status of the memory This value must be 64
Gives information of the status of the memory This value must be 8
1 Software
1 Software
Pow Off
W.Net A
DF
DESCRIPTION
Rev. 00 / July 2012
05 FAULT FINDING
Debug
ESC
xx.yy.zz
ER
Page / 08
02