Appendix D: Installing The Ssa-Wall-Mount Kit; Required Tools; Installation Site Requirements; Contents Of The Ssa-Wall-Mount Kit - Extreme Networks SSA-G8018-0652 Hardware Installation Manual

D
Installing the SSA-WALL-MOUNT
Kit

Required Tools

Installation Site Requirements

Contents of the SSA-WALL-MOUNT Kit

Preparing the Installation Site
Mounting the SSA Chassis on a Wall
This appendix provides instructions for installing the SSA on a wall using the optional SSA-WALL-
MOUNT kit.
Warning
Electrical hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
Risques d'électrocution: Seul un personnel qualifié doit effectuer les procédures d'installation.
Required Tools
Use the following tools to mount your SSA switch using the optional SSA-WALL-MOUNT kit:
•
ESD wrist strap (included)
•
Phillips screwdriver
Installation Site Requirements
Ensure that the installation site has a minimum of 15 cm (6 in.) of clear wall space at the top, bottom,
left side, and right side of the mounting bracket. This minimum clearance allows for proper airflow,
space for cabling the ports, and space for replacing power supplies.
Note
You must manage the port cables to ensure that the air vents are not blocked.
Contents of the SSA-WALL-MOUNT Kit
Table 24 lists the contents of the SSA-WALL-MOUNT kit.
S-Series Stand Alone (SSA) Switch Hardware Installation Guide 67