Unpacking The Power Supplies - Extreme Networks SSA-G8018-0652 Hardware Installation Manual

Figure 10: Securing the SSA Switch to the Rack in a Mid-Mount Configuration
1 = 4 to 6 screws or fasteners appropriate to the rack
You can now unpack and install the SSA power supplies. See
22.
Installing the SSA Switch on a Flat Surface
For flat surface installation, optionally attach the adhesive rubber feet to the bottom of the SSA switch.
To attach the rubber feet to the bottom of the SSA switch, follow these steps:
1 Place the SSA switch upside down on a sturdy, flat surface.
2 Remove the adhesive backing from the four rubber feet.
3 Adhere the rubber feet to the round, recessed areas on the bottom of the SSA switch.
4 Turn the SSA switch rightside up.
You can now unpack and install the SSA power supplies. See
22.

Unpacking the Power Supplies

The SSA-FB-AC-PS-A and SSA-FB-AC-PS-B power supply modules are shipped in boxes separate from
the SSA switch.
To unpack a power supply, follow these steps:
1 Remove the power supply from the shipping box and slide the two foam end caps off the unit.
Save the shipping box and materials in case the unit must be reshipped.
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
Unpacking the Power Supplies
Unpacking the Power Supplies
Installation
on page
on page
22