Mount The Device On A Wall (5320-16P Models) - Extreme Networks ExtremeSwitching 5320 Series Hardware Installation Manual

Mount the Device on a Wall (5320-16P models)

Figure 33: Mid-Mount: Attaching longer mounting ears to 5320-16P models
2. Use the small bracket-mounting screws (provided) to secure the mounting ear to the switch
housing. If using screws other than those provided, ensure that the threaded length of the screws is
within 4 to 5 cm.
3. Repeat step
4. Secure the mounting ears to the rack, using screws that are appropriate for the rack. (Rack-
mounting screws are not provided.)
Mount the Device on a Wall (5320-16P models)
The 5320-16P switch models are constructed so that they can be mounted on a wall. Ensure that the
wall is strong enough to support the weight of the switch and the attached cables.
Note
The front end of the switch must be facing down, and the power inlet must be facing up when
mounting a switch to the wall.
To mount a switch to the wall, follow these steps.
1. Using the two holes in each short mounting ear, mark the places on the wall to mount the switch.
Each mounting ear has two mounting holes, so be sure to make four marks. Be sure to position the
marks so that the switch is level when it is mounted.
2. Drill a hole at each mark.
3. Insert a provided anchor into each hole. Gently tap each anchor with a hammer, if necessary, to
ensure that it is inserted tightly.
4. Using rack mount screws, attach a wall-mounting ear to the left side of the switch, at the front end.
Figure 34
5. Repeat step
6. Mount the switch on the wall by screwing a provided wood screw through each hole in the wall-
mounting ears into the anchors. Ensure that all screws are securely fastened and that the switch is
firmly attached to the wall.
58 ExtremeSwitching 5320 Series Hardware Installation Guide
1 and step 2 to attach the other mounting ear to the other side of the switch.
shows the attachment of the screws.
4 for the right side of the switch.
Install Your Switch