Restart System - ZyXEL Communications MGS3750-28F User Manual

Figure 49 Firmware Upgrade Screen
The following table describes the labels in this screen.
Table 42 Firmware Upgrade Screen
LABEL
Choose File
Reboot After
Success
Choose File
Reboot After
Success
Choose File
Reboot After
Success

7.1.2 Restart System

Use this screen to choose to restart the system directly or restore the system to its default factory
settings. If the Switch has two systems, then it can be set to load the default system or the backup
system upon restarting.
Figure 50 Restart System Screen
The following table describes the labels in this screen.
Table 43 Restart System Screen
LABEL
Startup Application Select
Default Host
Chapter 7 Management
DESCRIPTION
Click Choose File to upload the BootRom file to the Switch.
The Switch will reboot after the file is uploaded successfully.
Click Choose File to upload the Host file to the Switch.
The Switch will reboot after the file is uploaded successfully.
Click Choose File to upload the Secondary file to the Switch.
The Switch will reboot after the file is uploaded successfully.
DESCRIPTION
When the Switch start up, it will run the default host software. This number is the software
version on the Switch and it will change once you upgrade/downgrade it.
MGS3750-28F User's Guide
62