Table of Contents
Advertisement
To toggle through the Executive modes:
1.
2.
3 3
1 1
RGB
EXEC
1
2
MODE
CONFIG
Figure 14.
HDMI/DTP Embedded Audio Output
By default, the embedded audio present on a selected HDMI or DTP input is routed to the
selected HDMI or DTP audio output. If an RGB input is selected, there is no audio output.
Optionally, program audio can be routed to the embedded output instead (see
Routing
NOTE: If the sink device connected to the HDMI output is DVI, then the signal is
HDMI Audio Mute
Set the Mute HDMI Audio dip switch (see figure 2,
mute the HDMI and DTP embedded audio output.
Program Audio
The selected audio input is simultaneously switched to the program variable audio output,
fixed audio output, and the volume level of the amplifier (MA and SA only). The front panel
input Indicator selected for program audio output blinks.
Embedded Audio and Analog Audio Output
If the selected HDMI or DTP input has embedded audio, the switcher extracts the digital
audio and converts it to analog for program audio output, fixed audio out, and the amplfiied
audio output (MA and SA only). If embedded digital audio is not available, the switcher
selects the current input analog audio (see figure 2,
NOTE: When the selected input has both embedded digital audio and analog audio
Press and hold the RGB input 1 button (see figure 14,
Press and release the digital inputs input 1 button (
Executive mode as follows:
a.
If Executive mode is not active (Exec Mode indicator off,
to Executive mode 1, the Mic Mute indicator flashes three times (
Exec Mode indicator turns on. Release both buttons to enter Executive mode 1.
b.
When in mode 1, the switcher toggles to Executive mode 2 and the Exec Mode
indicator (
) remains on. All front panel indicators flash three times. Release both
3
buttons to enter Executive mode 2.
c.
When in Executive mode 2, the switcher exits Executive mode and turns off the
Exec Mode indicator (
2 2
INPUTS
1
2
3
4
Toggle Executive Modes
on page 51).
converted to DVI format automatically. The result is that there is no embedded audio
output.
available, by default the switcher extracts the embedded digital audio for the audio
outputs. Using SIS commands, the default can be changed to select the analog audio
input instead (see
Audio Routing
each HDMI input .
2
). Release both buttons to exit Executive mode.
3
MUTE
5
6
on page 5) to permanently
M
, on page 5).
K
on page 51). This is individually configured for
) for more than 3 seconds.
1
). Each press toggles to the next
), the switcher toggles
3
), and the
4
4 4
MIC
PROGRAM AUDIO
MUTE
MEDIA PRESENTATION SWITCHER
Audio
MPS 602 • Operation
MPS SERIES
16
Advertisement
Table of Contents
