Table of Contents
Advertisement
Mute HDMI Audio and Phantom Power (see
M
2-position DIP switches.
The MUTE HDMI AUDIO switch (see figure 6) mutes the HDMI embedded audio on both
the HDMI output and the DTP output when the switch is in the UP position.
If your microphone requires phantom power, the PHANTOM POWER switch selects +48 V
phantom power for the mic input when in the UP position.
L
1
L
4
Figure 6.
Program Audio Output
Connecting the 5-pole captive screw stereo output connector
Balanced or unbalanced program audio output is available on the MPS 602 using a 5-pole,
3.5 mm captive screw connector. Refer to the following illustration for proper wiring.
ATTENTION:
•
For unbalanced audio, connect the sleeves to the ground contact. DO NOT connect
the sleeves to the negative (–) contacts.
•
Pour l'audio asymétrique, connectez les manchons au contact au sol. Ne PAS
connecter les manchons aux contacts négatifs (–).
NOTE: Do not tin the audio leads. Tinned wires are not as secure in the connector and
could be pulled out.
Do not tin the wires!
Figure 7.
Variable audio output — This 5-pole 3.5 mm captive screw connector outputs the
N
program audio.
NOTE: The variable audio output level is controlled by the front panel volume
encoder.
Mic Mix — One potentiometer controls the Mic Line input level (
O
the fixed audio output (
MIC
MIX
O P
Figure 8.
Fixed audio output — This 5-pole, 3.5 mm captive screw connector outputs balanced
P
or unbalanced fixed level program audio output. The front panel volume encoder
does not control the audio level from this audio output port.
R
L
2
R
L
3
R
MIC LINE
R
L
5
R
Mute HDMI Audio and Phantom Power DIP Switches
Tip
Ring
Sleeves
Tip
Ring
Balanced Audio Output
3.5 mm, 5-pole Captive Screw Audio Output Connectors
L
R
VARIABLE
).
P
L FIXED R
Mic Mix Level Control
figure 2
on page 5) — Two
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Audio Output
) that is mixed into
O
MPS 602 • Installation
8
Advertisement
Table of Contents
