Table of Contents
Advertisement
Amplified output (MA and SA models only) (see figure 9)
Q
MA models — One green 2-pole, 5 mm locking captive screw connector for mono 70V
output.
SA models — One green 4-pole, 5 mm locking captive screw connector for amplified
dual channel output to a 4 or 8 ohm speaker system.
1
Strip and insert the speaker wires into the
connector and tighten the captive screws.
Be sure to observe the correct polarit
T
O U
P
A M
V
7 0
I N
I R
2 W
S
A S
C L
1
Figure 9.
Control Ports
RS-232 remote — A 3-pole, 3.5 mm captive screw connector for connection of a host
R
computer or a controller using SIS or Windows-based control software.
Figure 10.
See
Reset button — Press and hold this recessed button until the front panel Power
S
LED (see figure 12,
MPS 602 to factory default settings (see
page 53).
USB Configuration Port (front panel) — (see
C
One mini type-B female USB jack for configuration and operation of the switcher, and
firmware upgrades (see
y.
Do not tin the wires!
MPS 602 MA
G
2
Amplified Output Connector Wiring
RS-232
Device
Transmit (Tx)
Do not tin
Receive (Rx)
the wires!
_
Ground (
)
RS-232 Captive Screw Connector Wiring
Remote Control Port (RS-232)
on page 13) flashes three times, then release to return the
A
Updating Firmware
2
Insert the wired connector into the amplifier
output and secure the locking screws on
either side.
1
Tx
Rx
G
Bidirectional
Transmit (Tx)
Receive (Rx)
_
Ground (
)
on page 44 for additional wiring details.
System reset (to factory defaults)
Front Panel Operation
on page 58).
MPS 602 • Installation
T
O U
P
4 Ω
A M
/
R
8 Ω
MPS 602 SA
L
G
I N
I R
2 W
S
A S
C L
2
on
on page 13)
9
Advertisement
Table of Contents
